Lull 944E-42 Service Manual Manuel d'utilisateur Page 38

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 846
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 37
General Information, Specifications and Maintenance
2.22
Model 644E-42/944E-42 Rev. 6/04
2.5.14 Tamper Proofing
A tamper-proof means is in place on the following
adjustable components prior to machine shipment. This
can either be tamper-proof paint, or a steel tamper-proof
cap. DO NOT attempt to defeat, by-pass or alter any
tamper-proof device.
Main Control Valve Assembly (8)
Accumulator Charge Valve Assembly (3)
Attachment Tilt Cylinder Counterbalance Valve (1)
Lift/Lower Cylinder Counterbalance Valve (1)
Extend/Retract Cylinder Counterbalance Valve (1)
2.5.15 Fork Ratings
All approved forks for this vehicle are marked with a
maximum load capacity rating. This rating (1) is stamped
on the right edge of the fork just below the fork pivot
shaft (2). The rating is listed in U.S. pounds and based
upon a 24" (610 mm) load center (3). This rating specifies
the maximum load capacity that the individual fork can
safely carry at the maximum specified load center.
Since forks are always used in multiples, the total rating
of any combination of forks will be the sum of their rated
capacity. All forks should be used in matched pairs.
644E Only: The maximum load capacity for this vehicle
is 6,000 pounds (2.721 Kg). The matched pair or set of
forks used on this vehicle should have total load ratings
which equal or exceed these weights. When the load
rating of the vehicle differs from the load capacity of the
forks, the lower value becomes the overall load capacity.
944E Only: The maximum load capacity for this vehicle
is 9,000 pounds (4.091 Kg). The matched pair or set of
forks used on this vehicle should have total load ratings
which equal or exceed these weights. When the load
rating of the vehicle differs from the load capacity of the
forks, the lower value becomes the overall load capacity.
XXXX - 24
XXXX - 24
OU0131
1
2
3
WARNING: DO NOT exceed the total
rated capacity of the specific pair of forks being
used. Forks can break causing loss of load and
possible death or serious personal injury to the
operator or personnel in the area. If the total
rated capacity of the forks exceeds
the
capacity of the vehicle, the vehicle capacity
should not be exceeded.
Vue de la page 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 845 846

Commentaires sur ces manuels

Pas de commentaire